Harman Stove Company 828i User Manual
8
INSERT TO A GAS SUPPLY
Burn Only the Fuel for Which the Heater is Equipped
The Clarity Fireplace Insert will burn either
natural gas or propane, but requires a dedicated
burner system module for either fuel. The label on
the burner system module indicates the fuel for
which it is equipped.
burner system module for either fuel. The label on
the burner system module indicates the fuel for
which it is equipped.
Making The Connection
The gas inlet is located at the bottom right rear of
the Insert. The inlet fitting
is a 1/4" male pipe
thread.
is a 1/4" male pipe
thread.
A separate gas shut-off
valve and a 1/8" N.P.T.
plugged tapping should
be installed immediately
upstream of the connec-
tion to the appliance.
plugged tapping should
be installed immediately
upstream of the connec-
tion to the appliance.
The ClarityFireplace
Insert must be discon-
nected from the gas supply piping during any
pressure testing of that system at pressures in
excess of 1/2 psig (3.5 kPa).
nected from the gas supply piping during any
pressure testing of that system at pressures in
excess of 1/2 psig (3.5 kPa).
The Clarity gas control valve must be in the OFF
position during any pressure testing of the gas
supply system at pressures equal to or less than
1/2 psig (3.5 kPa).
supply system at pressures equal to or less than
1/2 psig (3.5 kPa).
WARNING: To avoid pipe compounds from
entering into the gas train, apply compounds
only to the male pipe threads and only to the first
two threads.
only to the male pipe threads and only to the first
two threads.
CAUTION: TEST ALL JOINTS FOR LEAKS
PROPANE
NATURAL
Inlet
Log Positions When Assembled
Install the center log so that it goes all the way to
the back and is centered. When properly posi-
tioned, there should be an even gap along the front
of the center burner in the cavity in the log. A
small portion of the log support frame will be
revealed. The center log has a round viewing port
in the left end through which the pilot can be
observed.
tioned, there should be an even gap along the front
of the center burner in the cavity in the log. A
small portion of the log support frame will be
revealed. The center log has a round viewing port
in the left end through which the pilot can be
observed.
Install the cross log, making sure that it is ori-
ented with the forked end toward the left rear of
the stove, and slip it over the front locator pin and
position as shown below.
the stove, and slip it over the front locator pin and
position as shown below.
Re-install and Secure the Glass door
NOTE: The glass door is heavy. Lift it carefully to
prevent damage. Center the glass on the opening
and suspend it in place by placing the tab hooks
over the top edge of the opening. Press the glass
slightly against the stove to confirm that it seats
properly, then press it firmly against the front
while pushing the levers to the rear to engage
them.
and suspend it in place by placing the tab hooks
over the top edge of the opening. Press the glass
slightly against the stove to confirm that it seats
properly, then press it firmly against the front
while pushing the levers to the rear to engage
them.