Dimplex DWF1146GP User Manual

9

 WARNINg: Disconnect power before attempting 

any maintenance or cleaning to reduce the risk of 

fire, electric shock or damage to persons.

Allow at least five (5) minutes for light bulbs to cool 

before touching bulbs to avoid accidental burning of 

skin. Light bulbs need to be replaced when you notice 

a dark section of the flame or when the clarity and 

detail of the log exterior disappears. There are two (2) 

bulbs under the log set which generate the flames and 

embers.

It is a good idea to replace all light bulbs at one time 

if they are close to the end of their rated life.  Group 

replacement will reduce the number of times you need 

to open the unit to replace light bulbs. 

Light Bulb Requirements
Quantity of three (3) – 60 Watt chandelier or 

candelabra bulbs with E-12 (small) socket base,  

120 Volt. 
Do not exceed 60 Watts per bulb.

①

  Unplug the unit from the outlet.

②

  Remove glass assembly as shown in Figure 4.

③

  Reach in and turn the burnt-out bulb(s) (or all 

bulbs) counter-clockwise to remove.

④

  Replace with new bulbs.

⑤

  Fit glass assembly back in place.

⑥

  Plug in the fireplace. 

 

The front glass is cleaned in the factory during the 

assembly operation.  During shipment, installation, 

handling, etc., the front glass may collect dust 

particles, these can be removed by dusting lightly with 

a clean dry cloth.
To remove fingerprints or other marks, the glass can 

be cleaned with a damp cloth.  The glass should be 

completely dried with a lint free cloth to prevent water 

spots.  To prevent scratching, do not use abrasive 

cleaners or spray liquids on the glass surface.

To remove fingerprints or other marks, the exterior 

finish can be cleaned with a damp cloth with a mild 

detergent.  The surface should be completely dried 

with a lint free cloth to prevent water spots.  

To prevent scratching, do not use abrasive cleaners or 

spray liquids on any surface.