Dimplex VCX1525-WH User Manual

7

NOTE:  a 15 amp, 120 Volt  

circuit is required.  a dedicated  

circuit is preferred but not 

essential in all cases.  a 

dedicated circuit will be 

required if, after installation, 

the circuit breaker trips or the 

fuse blows on a regular basis 

when the heater is operating. 

additional appliances on the 

same circuit may exceed the 

current rating of the circuit 

breaker.

 WARNINg:  Ensure the power  

cord is not installed so that it is  

pinched or against a sharp  

edge and ensure that the 

power cord is stored or 

secured to avoid tripping or 

snagging to reduce the risk of 

fire, electric shock or injury to 

persons.

  Construction and electrical 

outlet wiring must comply 

with local building codes and 

other applicable regulations to 

reduce the risk of fire, electric 

shock and injury to persons.

  Do not attempt to wire your  

own new outlets or circuits. To 

reduce the risk of fire, electric 

shock or injury to persons, 

always use a licensed 

electrician.

①

  Before using the In-Stud 

fireplace verify:
•   Are the circuit breakers for the  

unit on?

•   Are the light bulbs loose? (to  

check, follow the instructions  

for replacing the light bulbs 

under the maintenance section 

of this manual) 

②

  The heater may emit a slight, 

harmless odor when first used. 

This odor is a normal condition  

caused by the initial heating of 

internal heater parts. 
③  The information regarding the 

model of your unit can be found 

on the model and serial number 

plate located on the side of the 

unit. see Page 3 for an illustration 

on how to locate the rating plate.