Dimplex DFG2562 User Manual
7
Site Selection and
Preparation
!
NOTE 1: A 15 Amp, 120 volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNINg: Ensure the
power cord is not installed so
that it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
①
select a suitable location that
is not susceptible to moisture and
is away from drapes, furniture and
high traffic.
②
For ease of electrical hook
up you may wish to locate the
Installation
fireplace near an existing outlet
(refer to noTE 1) for plug-in
convenience.
If installing a new outlet for this
electric fireplace:
Construction and electrical
•
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
Do not attempt to wire your
•
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
always use a licensed
electrician.
The dimensions of the firebox are
26 inches (660.5 mm) wide X
18 ⅞ inches (479.5 mm) high
X 8 ¾ inches (223 mm) deep.
The firebox does not require any
additional venting.
For all installation options, ensure
that the fireplace opening has the
following
MINIMUM dimensions
(Figure 1):