Leica GS20 User Manual
Setup
Leica GS20 Field Guide-1.1.0en
81
8. Finally, press the Menu key and Save, then Escape back
to the main menu.
Tip: Ensure batteries are charged and correctly inserted.
Ensure bluetooth module is set to line and on. The
single flashing red light indicates that power is
available. When the light changes to green a
BLUETOOTH connection is established but no data is
exchanged. When both green lights are flashing data is
exchanged.
single flashing red light indicates that power is
available. When the light changes to green a
BLUETOOTH connection is established but no data is
exchanged. When both green lights are flashing data is
exchanged.
9.8.4.3 Checking the WoRCS Real-Time Link
Once the Bluetooth Link is established, you will need to make
sure that your real-time device is linked and active. If the
status message “Reference Data is Available” appears, setup
is complete, and there is no need to proceed any further.
Otherwise, follow the steps of the status check below.
sure that your real-time device is linked and active. If the
status message “Reference Data is Available” appears, setup
is complete, and there is no need to proceed any further.
Otherwise, follow the steps of the status check below.
9.8.4.4 WoRCS Real-Time Beacon
1. From the Main Menu select 9 Status. Expand the
Interfaces branch and select Real-Time. If you have
communication with the Real-time Beacon module (RTB),
you will see information about the frequency, signal
strength etc; otherwise, you will see all zero values.
communication with the Real-time Beacon module (RTB),
you will see information about the frequency, signal
strength etc; otherwise, you will see all zero values.
)
The real-time screen does not refresh automatically; to
refresh the values, you will need to escape and re-enter.
refresh the values, you will need to escape and re-enter.