Mitsubishi Electronics MSZ-FD35VAS User Manual

36

(1)  Slide the sleeve and check if there is a locking lever or not.

(2) The terminal with this connector has the 
      locking mechanism.

1

Slide the sleeve.

2

Pull the terminal while 

   pushing the locking
   lever.

1

Hold the sleeve, and 

   pull out the terminal 
   slowly.

The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached  by pulling it out.
Check the shape of the terminal before detaching.

<"Terminal with locking mechanism" Detaching points>

(1) Press and unlock the knobs on both sides of the front

panel and lift the front panel until it is level. Pull the hinges
forward to remove the front panel.

(2) Remove the horizontal vanes.
(3) Remove the screw caps of the panel. Remove the screws.

(See Photo 1)

(4) Hold the lower part of both ends of the panel and pull it

slightly toward you, and then remove the panel by pushing
it upward.

NOTE :
Turn OFF power supply
before disassembling.

Screws of the panel

Front panel

Horizontal vane

OBH488-2.qxp  07.8.9 11:49 AM  Page 36