Haier AB122XCERA User Manual

15

6. Installation of Ornament Panel

Install ornament panel on indoor unit

(1) Check whether indoor unit is horizontal with leveler or polythene pipe filled with water , and
      check that the dimension of the ceiling opening is correct. Take off the lever gauge before install
      the ornament panel.
(2) Fasten the screws to make the height difference between the two sides of indoor unit less than
     5mm.

(3) First fix it with screws temporally.

(4) Fasten the two temporally fixing screws and other two, and tighten the four screws.

(5) Connect the wires of swing-motor.

(6) Connect the wire of signal.

(7) If no response of remote controller,check whether the wiring is correct,restart remote controller
     10 seconds after shut off power supply.

Limits of panel board installation

(1)Install the panel board in the direction shown in
     the figure.
(2)The incorrect direction will result in water leakage,
     meanwhile swing and signal receiving are displayed
     that cannot be connected.

Control box