Soleus Air MAC-10K User Manual

 

 

6

 
When you use the unit as an air conditioner or a dehumidifier, the fresh outdoor air must 
be directed to the unit and the hot air must be exhausted out of the room to complete the air 
exchange. When the unit is operating on fan or heating models, no outdoor air exchange 
takes place. You do not need to hookup the window kits and exhaust hose when you use the 
unit as a fan or a heater. 

 

a) 

Pull out of both ends of the exhaust ducts for approximately 6”. 

b) 

Screw clockwise the exhaust ducts with one end to the terminal end and other end 
to the window kit adapter. 

c) 

Remove exhaust outlet wall covers from the back of the unit by screwing the covers 
counter-clockwise before lifting them up. 

d) 

Mount terminal ends of the exhaust hoses to the unit. 

e) 

Open window or sliding door for approximately 5 inches (130 mm) 

 

f) 

Adjust the length of the window kit to the same length of the window or the sliding 
door.  Use all three panels if necessary.  Cut the window piece as needed to fit the 
length of your window or sliding door.  Make sure that both holes on the main piece 
are not covered by other pieces. 

g) 

Place the window kit to the window or sliding door. Close the window or door as 
far as it goes. 

h) 

Adjust the lengths of exhaust hose and affix the window kid adapters onto the holes 
on the window kit. 

 
NOTE: When using the window kit on a window or sliding door it will cause the window 
or sliding door not to be properly closed and locked.  Additional security measurements 
should be taken 

 

Wall Mount 
 
1) 

Do not use window kit adapter.  Mount the one end of the exhaust ducts onto holes 
of 5” on the wall. 

2) 

Using exhaust outlet wall covers to cover the holes in the wall when the unit is not 
in use. 

 

NOTE: In order to increase the efficiency, the exhaust ducts should be keeping as short and 
straight as possible.  It is not recommended to increase the manufacturer’s length of the 
exhaust hose. This may impede or damage the unit.