GE AGQ10 User Manual
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
7
GEAppliances.com
Additional controls and important information.
Vent Control
The vent control is located above the
control knobs.
control knobs.
When set at CLOSE, only the air inside the room will
be circulated and conditioned. When set at OPEN,
some inside air is exhausted outside.
be circulated and conditioned. When set at OPEN,
some inside air is exhausted outside.
To open the vent, pull the lever toward you.
To close it, push it in.
To close it, push it in.
Air Direction – Side-to-Side
On some models, the side-to-side air direction is
adjusted by moving the lever to the left or right.
adjusted by moving the lever to the left or right.
CIRCULAIRE (on some models)
For fixed side-to-side air direction, set the
Circulaire switch to ON until the desired air
direction is obtained, then move it to OFF.
Circulaire switch to ON until the desired air
direction is obtained, then move it to OFF.
For continuous side-to-side air circulation (cool
settings only), set the Circulaire switch to ON.
settings only), set the Circulaire switch to ON.
Energy Saver
(on some models)
The energy saver switch controls the fan.
ON ---The fan and compressor cycle on and off
together. This results in wider variations of room
temperature and humidity. Normally used when
the room is unoccupied.
together. This results in wider variations of room
temperature and humidity. Normally used when
the room is unoccupied.
OFF ---The fan runs all the time, while the
compressor cycles on and off.
compressor cycles on and off.
This switch must be set at OFF in order to use the
fan settings (on the mode control).
fan settings (on the mode control).
Air Direction – Up and Down
Fingertip pressure on the horizontal louvers adjusts
the air direction up or down.
the air direction up or down.
(on some models)