GE ASQ05 User Manual

4

■ 

To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.

■ 

The remote control signal has a range of 
up to 21 feet.

■ 

Make sure nothing is between the air conditioner
and the remote control that could block the
signal.

■ 

Make sure batteries are fresh and installed
correctly–see the Care and Cleaning section.

Turns air conditioner on and off.

Shows the set temperature, time remaining
on timer or fan speed (1–LOW, 2–MED or
3–HIGH).

Use to set the air conditioner to COOL or 
FAN mode.

▲ 

▼

Use to set temperature when in COOL mode.

Use to set the fan speed to LOW (1), MED (2) or
HIGH (3).

ON–When the air conditioner is off, it can be
set to automatically turn on in 1 to 12 hours
at its previous setting. Each touch will set the
time in hours.

OFF–When the air conditioner is on, it can be
set to automatically turn off in 1 to 12 hours.
Each touch will set the time in hours.

To cancel the timer, press the TIMER pad 
until the display time disappears.

Controls the fan.

ON – The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied. NOTE: The
fan will continue to run for a short time
after the compressor cycles off.

OFF – The fan runs all the time, while the
compressor cycles on and off.

This switch must be set at OFF in order to use
the fan settings (on the mode control).

In the case of a power outage or interruption, the

unit will automatically re-start in the settings last
used after the power is restored. The TIMER feature

will reset to the original setting. You may need to 
set a new time if desired.