Goldstar LT1230CR User Manual

-

 Push this button to shift mode of operation from COOL 

→ ENERGY SAVER → FAN.

- COOL:

• Fan runs continually for normal cooling operation.

- ENERGY SAVER:

• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will 

check the room air temperature to determine if cooling is needed.

- FAN:

• Fan-only operation.

- SHUT-OFF TIME

• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature 

setting will raise 2

°F after 30 min., and once again after another 

30 min.

• Push Timer button to advance setting from 1Hour 

→ 2Hours → ... 

→ 12Hours maximum.

- START TIME

• If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1Hour 

→ 2Hours → ... 

→ 12Hours maximum.

• Use this button to automatically control the 

temperature of the room. 
The temperature can be set within a range of 
60

°F to 86°F by increments of 1°F. 

• The setting appears in the display.

• To turn the air conditioner ON, push this button. 

To turn the air conditioner OFF, push the button 
again.

• This button takes priority over any other button.
• When you first turn it on, the unit is in cool 

mode, High fan speed, Temperature setting at 
72

°F.

• Every time you push this button, it advances the setting as follows: {High 

→ Low → Med → High}