Friedrich CP15F10A User Manual

 

³⁄₄ 

B

A

A

■

Use 2" x 4" or thicker lumber for wood frame.

4. Apply wood preservative to the outside exposed surface.

5. Insert the frame in the wall opening. Square and level frame. 

6. Attach frame securely to the wall.

1. Remove top channel and both side channels using a 

¹⁄₄" nut 

driver or socket wrench. Discard top channel and both side 
channels.

A

B

C

3.  Insert cabinet into the framed wall opening. the top of the cbine

should extend ¾" (19.1 mm) into the room. If there is trim, the
cabinet should extend ¾" (19.1 mm)  past the trim.

5.  Check that air conditioner cabinet is tilted to the outside so that

water will run to the outside.

6.  Reuse the insulation to seal opening between cabinet and

frame. 

7. Use 

existing holes in sides and top of cabinet and 7 - #10 x 1"

wood screws (not provided) to attach cabinet to frame.

NOTE: Do not overtighten screws or cabinet will distort and
provide a poor air seal between cabinet and air conditioner.

8.  Caulk all outside wall openings around cabinet.

4.  Use a level to check that cabinet is level side to side.

NOTE: Handle air conditioner carefully and gently.

1. Make sure the free end of the ground wire is outside of the 

cabinet.

2. Insert air conditioner into cabinet. 

A

2. Cut two pieces of standard 1" lumber (supplied by installer) to the 

i

f t d d 1" l

b

(

li d b i t

length and width required. Place in front and back of bottom sill 
channel. Secure with nails (supplied by installer).

to move and install

10