Toshiba RAV-SM802UT-E User Manual

– 140 –

Partition plate

Compressor

Case thermo

lead

Heat exchanger

Screw

Valve 
support board

Screws (2 pcs.)

Compressor bolt (3 pcs.)

Remove 
(Suction pipe)

Remove 
(Discharge pipe)

Reactor

Partition 

plate

Reactor 

support board

‡

ˆ

Compressor

Reactor

1) Perform works of items 1 of 



 and

‚

, 

ƒ

, 

„

, 

…

.

2) Discharge refrigerant gas.
3) Remove the partition plate.

(ST1T Ø4 × 10L, 2 pcs.)

4) Remove the noise-insulator.
5) Remove the terminal covers of the

compressor, and disconnect lead
wires of the compressor and the
compressor thermo assembly from
the terminal.

6) Remove pipes connected to the

compressor with a burner.

Pay attention to that flame does not
involve 4-way valve or PMV. (If doing
so, a malfunction may be caused.)

7) Take off the fixing screws of the

bottom plate and heat exchanger.
(ST1T Ø4 × 10L, 2 pcs.)

8) Take off the fixing screws of the valve

clamping plate to the bottom plate.

9) Pull upward he refrigerating cycle.
10) Take off nut fixing the compressor to

the bottom place.

When reconnecting the lead wires to
the compressor terminals after
replacement of the compressor, be
sure to caulk the Faston terminal
without loosening.

1) Perform works of item 1 of 



 and 

ƒ

.

2) First take off two screws

(ST1T Ø4 × 10L) of the reactor fixed
to the reactor support.

3) Remove the reactor support from the

partition plate.
(ST1T Ø4 × 10L, 4 pcs.)

4) Take off two screws

(ST1T Ø4 × 10L) directly attached to
the partition plate.