Graco 24R200 User Manual

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-
tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When 
these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific 
hazard symbols and warnings not covered in this section may appear throughout the body of this manual where 
applicable.

The heated platen kit is a field installed kit to add heat to 
the platen. The additional heat may change the viscosity 
properties of the material and allow the material to flow 
easier through the system.

A 25A (minimum) - 30A (maximum) circuit breaker must 
be installed on the incoming power supply.

This equipment must be grounded. Improper grounding, setup, or usage of the system can cause electric 
shock.
•

Turn off and disconnect power at main switch before disconnecting any cables and before servicing 
or installing equipment.

•

Connect only to grounded power source.

•

All electrical wiring must be done by a qualified electrician and comply with all local codes and 
regulations.

Equipment surfaces and fluid that’s heated can become very hot during operation. To avoid severe burns:
•

Do not touch hot fluid or equipment.

240 V

3,500 per Platen

20