Carrier 48TM007-012 User Manual

2

Date:

Supersedes:

48T

Rev.: 

-1SB

JOB NAME:

LOCATION:

BUYER:

BUYER P.O. #

CARRIER #

UNIT NUMBER:

MODEL NUMBER:

UNIT DESIGNATION:

PERFORMANCE DATA CERTIFIED BY:

DATE:

Units are a single piece, gas heating/electric cooling unit, with a low profile, pre-wired, tested and charged at the factory.
The units have the capability for convertible supply and return openings and are intended for installation on an accessory
curb (ordered separately), or for slab mounting (for horizontal duct connections). Units are designed to accept a field-
installed economizer, enthalpy control, manual or 2-position outside air damper, roof curb, as well as 3 choices of gas heat.
Refer to accessory chart below for full listing.

• Standard one-year full product warranty.
• Five-year protection plan for the motor-compressor.
• Five-year protection plan on heat exchangers.
• Outdoor ambient cooling operation from 25 F (–4 C) to 115 F (46 C).
• Units are tested and certified by ARI and certified by UL and CSA.

Factory-run test printout included in each rooftop.

• 24-volt control circuit, with resettable breaker.
• Two-inch disposable-type return air filters in dedicated rack.
• Hermetic compressor on independent circuit with internal line break and

overload protection, self-lubricating with internal discharge muffler.

• Scroll compressor with internal overload protection (TF/TM007,

TM012, TF014).

• Refrigerant circuit contains a filter drier to trap dirt and particles.
• Single compressor on 3 to 6 ton units.
• Dual compressors on 7

1

/

2

 to 12

1

/

2

 ton units.

• Two-speed direct drive evaporator fan on all units except 007 size which

is belt driven. Adjustable belt drive fans are optional on all sizes.

• Non-corrosive condensate pan with self-draining sloping design with

both bottom and side drain connections.

• Thru-the-bottom power control and gas entry capability.
• Indoor and outdoor coils constructed of aluminum fins mechanically

bonded to seamless copper tubes.

• Single point electrical and gas connections.
• Direct drive propeller condenser fan totally enclosed with permanently

lubricated bearings.

• Pre-painted, insulated cabinet with primer inner panels, certified 500-hr

salt spray test and non-corrosive screws.

• Dedicated L,M,N 3 to 5 ton “Low NOx” units that meet California air

quality refrigerant of 40 nanograms/joule or less.

• Large, easily removable panels provide ready access to unit components

for rapid removal or maintenance.

• Filter access door for filter access and maintenance that requires no tools.
• Induced draft (negative pressure) combustion system with Hall effect

sensor to detect proper operation of induced draft motor.

• All units have single stage cooling and single stage heating capability.

High heat models have 2-stage heating capability.

• Heavy Alumagard™ coated heat exchangers, with aluminized steel

burners.

• Heating controls with direct spark ignition and redundant gas valve. Fan

switch, high temperature limit switch and flame rollout switch standard.

• Fixed orifice metering device precisely controls refrigerant flow to each

circuit individually.

• Reliable accurate control circuit with color coded wires and easy acces-

sible terminal board.

• Integrated gas control board with built-in diagnostics to determine error

codes and control indoor fan on/off delays.

• Integrated gas control board provides anti-cycle protection for gas heat

operation.

• Loss of charge (low pressure), freeze protection, and high pressure

switches standard.

• Refrigerant filter drier/circuit.

Net Total Cap.___________________________________________ Btuh

Net Sensible Cap. ________________________________________ Btuh

Compressor Power Input ___________________________________ kW

_________________________________________ F Outdoor Air Temp.

Indoor Entering Air    db _____________ F

wb _______________ F

CFM __________

Ext. Static Pressure___________________ in. wg

Fan RPM  _______________________________________________ Bhp

SEER/EER _________________________________________________

Input:

Stage 1  ___________________ Total______________ Btuh

Output:

Stage 1 ____________________ Total______________ Btuh

AFUE _______________________________ kW_________________%

Steady State _______________________________________________%

Operating Weight _______________ lbs. (unit)_____________ lbs. (curb)

Power Supply to Unit ________________ Volts ________________ Phase   _________________________ Hz

Minimum Circuit Amps ______________ Maximum Overcurrent Protection (Fuse Only) _______________

 Durablade Economizer — Fully Modulating

 EconoMi$er with Controller

 Copper/Copper Coils — Evaporator,

Condenser, Both

 Pre-Coated Condenser Coil

 E-Coat (Post-Coated) Condenser Coil

 Non-Fused Disconnect Switch

 115-Volt Convenience Outlet

 Apollo Communicating Control

 PremierLink™ Control

 25% Manual Air Damper

 Alternate Motor and Drive (except 007 and 009 size)

 High-Static Motor (except 014)

 EconoMi$er with 4-20 mA Actuator, Less Controller

 Durablade Economizer — Fully Modulating

 EconoMi$er

 25% Open Two-Position Damper

 25% Open Manual Air Damper

 100% Open Two-Position Damper

 Solid-State Enthalpy Control

 Differential Enthalpy Control

 Roof Curb (14- or 24-in. Height)

 Thru-the-Bottom/Roof Curb Electrical and 

Gas Connection Kit

 Time Guard® II Compressor Anti-Cycle

Control

 Condenser Coil Hail Guard

 Room Temperature Sensor

 PremierLink™ Control

 Condenser Coil Protector (004-007)

 EconoMi$er/Power Exhaust

 –20 F Motormaster® Low Ambient Control 

Kit

 Programmable Set-Back Thermostat

 Electrical Mechanical Thermostat & Subbase

 Liquid Propane (LP) Gas Kit

 Flue Hood Protector Kit

 Flue Discharge Deflector

 Indoor Fan/filter Status Indicator

 62AQ Energy$Recycler

 Other ____________________