APC ACPA4000 User Manual
3
NetworkAIR ACPA4000
Safety
Warning: Use the equipment on a flat surface.
Do not obstruct the equipment air outlets.
For indoor use only.
Do not attempt to service the equipment except to clean and replace the air filters. The equipment
contains no other user-serviceable parts.
contains no other user-serviceable parts.
Do not place the rear of the equipment closer than 203 mm (8 in) to any wall or obstacle.
Do not install the equipment where there are fumes or flammable gases, or in an extremely humid
space such as a greenhouse.
space such as a greenhouse.
Do not place this equipment on its side. If the equipment has been tipped, place it upright on a
flat, solid surface and keep it in this position for a minimum of 12 hours before operating.
flat, solid surface and keep it in this position for a minimum of 12 hours before operating.
Electrical Hazard: Connect the equipment to a 3-wire AC outlet (two poles plus a ground).
The receptacle must be connected to a dedicated, properly grounded 115 volt 60Hz branch circuit
rated for 20 amp main protection (fuses/circuit breaker). Connection to any other power source
may result in a shock hazard or damage to the equipment.
The receptacle must be connected to a dedicated, properly grounded 115 volt 60Hz branch circuit
rated for 20 amp main protection (fuses/circuit breaker). Connection to any other power source
may result in a shock hazard or damage to the equipment.
Use the equipment with the supplied power cord only.
Do not use an extension cord.
Inspecting the Equipment
Your equipment has been tested and inspected for quality assurance before shipment. To ensure that the
equipment has not been damaged during transit, carefully inspect both the exterior and interior
packaging of the equipment immediately upon receipt.
equipment has not been damaged during transit, carefully inspect both the exterior and interior
packaging of the equipment immediately upon receipt.
Verify that all parts ordered were received as specified. See “Inventory” on page 4.
Filing a claim
If damage is identified on receipt of the equipment, note the damage on the bill of lading and file a
damage claim with the shipping company. Contact APC for information on filing a claim with the
shipping company. The shipping claim must be filed at the receiving end of the delivery.
damage claim with the shipping company. Contact APC for information on filing a claim with the
shipping company. The shipping claim must be filed at the receiving end of the delivery.
Note: In case of shipping damage, do not operate the equipment. Keep all packaging for
inspection by the shipper and contact APC customer support at one of the numbers listed on the
back cover of this manual.
inspection by the shipper and contact APC customer support at one of the numbers listed on the
back cover of this manual.
Storing the Equipment Before Installation
Caution: Leaving the equipment uncovered and exposed to the elements can cause damage
and voids the factory warranty.
and voids the factory warranty.