APC ACPA4000 User Manual
NetworkAIR ACPA4000
12
Accessories
Temperature/humidity sensor
The Remote Temperature/humidity sensor (AP9512TH) monitors the room temperature and
relative humidity. This remote sensor monitors the environment surrounding the cooling
equipment to ensure that the conditioned air is cooling the desired area.
relative humidity. This remote sensor monitors the environment surrounding the cooling
equipment to ensure that the conditioned air is cooling the desired area.
To install the sensor:
1. Determine a location that allows you to neatly route and secure the 3.66-m (12-ft) cord near the
heat source you want to control.
Note: Avoid locating the sensor in areas that could give you an inaccurate reading such
as near air ducts, other heat sources, windows, direct sunlight, or room entrances.
as near air ducts, other heat sources, windows, direct sunlight, or room entrances.
2. Attach the sensor to a wall or other
surface with the provided
hook-and-loop fasteners.
hook-and-loop fasteners.
3. Neatly route and secure the 3.66-m
(12-ft) cord with wire tie or cable
clips.
clips.
4. Connect the sensor to the controller
board at the rear of the equipment.
Note: The equipment cannot be controlled based on the temperature measured by
the sensor.
the sensor.
na
01
74
a