APC ACPSC3000 User Manual

Electrical Hazard: Before performing maintenance on the cooling unit:

 

1. Turn the cooling unit off.

 

2. Unplug the cooling unit.

Warning: Damage to equipment may occur if:

 

1. Caustic substances are used to clean the cooling unit. 

 

2. The unit is subjected to excess water.

 

2. Air filters are cleaned too aggressively or allowed to dry in direct sunlight.

Wipe dirt and dust from the exterior surfaces with a soft, dry cloth. Dampen a cloth with a solution of 
warm water and mild detergent for heavily soiled areas.

Ensure all detergent is wiped from the surface with a clean, damp cloth to remove residue.

Check the air filter frequently after initially putting the cooling unit into service. Determine how long 
between cleanings you can wait. Keeping your air filter clean will maximize the performance and life of 
the cooling unit.

1. Remove the air filter. Press down on the two 

tabs on the top of the grill to release the filter 
and grill from the cooling unit. 

– Carefully pull the air filter from the plastic 

hooks on the inside of the grill. 

2. Clean the air filter. About every two to three 

weeks clean by gently vacuuming, wiping the 
filter with a dry cloth, or knocking the filter 
on a firm surface to dislodge dust. Do not use 
water to clean the filter.

See “Remove the air filter” (above) for instructions 
to properly remove the air filter. 

1. Install a new, clean filter by pressing the filter 

onto the hooks on the grill. 

2. Attach the grill to the rear of the cooling unit. 

Set the bottom of the grill into the opening. 
Tabs on the grill bottom should enter the slots 
in the bottom of the opening. 

3. Tip the top of the grill up and into the 

opening. The tabs on the top of the grill 
should snap into place.

MODE

TEMP

na3369a