Regency Wraps F2400M User Manual

Regency Freestanding Woodstove

17

Remove the door from the stove and remove 
the glass retainer. Position the glass in the door, 
make sure that the glass gasketing will properly 
seal your unit, and replace the retainer, it should 
rest on the gasket not the glass. Tighten securely, 
but do not wrench down on the glass as this 
may cause the glass to break.

Firebrick is included to extend the life of your 
stove and radiate heat more evenly.  Check to 
see that all fi rebricks are in their correct posi-
tions and have not become misaligned during 
shipping.

The "AD" brick in the drawings below is the brick 
covering the Ash Dump hole that is used when 
the Ash Drawer Kit is installed. 

Attach spring handle by rotating counter clock-
wise onto rod. Ensure that the rod fi ts into the 
entire length of the spring handle (refer to the 
Diagram below).

The pieces listed below can be purchased and 
installed during the initial installation or added 
on later.

1)  Remove the bricks from the fl oor of the 

fi rebox.

2)  If using ashdrawer, discard cover plate.
 
3)  Remove the ash dump cover plates (one 

inside the fi rebox and one on the underside 
of the fi rebox) by removing the two nuts and 
bolts holding the 2 plates together from inside 
the fi rebox.

4)  Push the ash plug into the hole inside the 

fi rebox and replace all the bricks except for 
the brick over the ash plug (refer to the  brick 
diagram in the Brick Installation section).

5)  Place the ash drawer lid inside the pedestal, 

and the ash plug tool beside the lid, then 
slide the ash drawer inside so it sits on top 
of the lid. 

Hook screen to the inside on the right side 
of the fi rebox door opening. Lock in place by 
turning handle.

1)  Remove the bricks from the fl oor of the 

fi rebox.

2)  Remove and discard the cover plate by 

removing the two screws on the front of the 
Bottom Shield.

 
3)  Remove the ash dump cover plates (one 

inside the fi rebox and one on the underside 
of the fi rebox) by removing the two nuts and 
bolts holding the 2 plates together from inside 
the fi rebox.

4)  Push the ash plug into the hole inside the 

fi rebox and replace all the bricks except 
for the brick over the ash plug (see brick 
diagram in the Brick Installation section).

5)  Place the ash plug tool beside the lid, then 

slide the ash drawer inside.

Refer to Ash Drawer Operating Guidelines in 
the Operating Instructions section.

NOTE: The handle must be positioned at 10 
o'clock when closed to avoid the handle from 
getting hot and to ensure the screen stays in 
place.