Regency Wraps F2400M User Manual

Regency Freestanding Woodstove

8

with Airmate                  15" (381 mm)     5.5" (139 mm)     4" (101 mm)   27" (685 mm)    12" (304 mm)    15.5"  (393 mm)

with Rear Defl ector       15" (381 mm)   6.5" (165 mm)     6" (152 mm)   27" (685 mm)    13" (330 mm)    17.5" (444 mm)

Medium S2400M Step Stove                        15" (381 mm)   5.5" (139 mm)     4" (101 mm)   27" (685 mm)    12" (304 mm)    15.5" (393 mm)

with Airmate                16" (406 mm) 

11" (279 mm)   6" (152 mm)     28" (710 mm)    17.5" (444 mm)    17.5" (444 mm)

with Rear Defl ector     18" (457 mm) 

12" (304 mm)   6.5" (165 mm)  30" (762 mm)    18.5" (469 mm)    19.5" (495 mm)

Medium S2400M Step Stove                     16" (406 mm) 

11" (279 mm)   6" (152 mm)     28" (710 mm)    17.5" (444 mm)    17.5" (444 mm)

When the stove is installed as a close clearance residential unit, a listed double wall connector is required from the stove collar to the ceiling 
level.

 

"C" Vent single wall pipe is not approved for Mobile Home installations. (Refer to Mobile Home Instructions.)   

             with Airmate                              15" (381 mm)       5.5" (139 mm)     4" (101 mm)   27" (685 mm)   12" (304 mm)    15.5"  (393 mm)

             with Rear Defl ector                   15" (381 mm)      6.5" (165 mm)     6" (152 mm)   27" (685 mm)   13" (330 mm)    17.5" (444 mm)

Medium S2400M Step Stove                         15" (381 mm)      5.5" (139 mm)     4" (101 mm)   27" (685 mm)    12" (304 mm)    15.5" (393 mm)

For installation using room air for combustion, 
remove knockout from the pedestal, and/or from 
the bottom if using a heat shield.

Mobile home installations require the use of 
outside air.

Please read the section below carefully as clearances depend on whether the airmate or the 
rear heat defl ector is installed on the stove.

Measurements "From Unit" are from the top plate of the stove to a side wall or to a corner, 
and from the rear heat shield to a back wall.

On pedestal units there are two locations where 
outside air may be adapted to the unit. If us-
ing the bottom of the pedestal, do not remove 
knockout from the rear of the pedestal. Only 
remove rear knockout if outside air will be 
brought in from the rear.

On leg units outside air can only be brought in 
from the bottom of the heat shield.