England's Stove Works 25-PDV User Manual
ACCESSORY ITEMS
The following accessories can be added to your unit at anytime after purchase; however, let
the unit cool down before adding any accessories.
Thermostats
WALL: An external wall thermostat (such as our Part # GU-1E30-914) can be used on
our pellet units as long as it is a low-voltage that works with millivolt systems. After
unplugging the unit, locate the jumper wire (J-3) on the bottom of the control panel. The two
screws should then be loosened and the jumper wire removed from the board. Next, the two
thermostat lead wires should be slipped into these openings and the screws tightened; the
jumper wire should be saved for future operation without a thermostat.
our pellet units as long as it is a low-voltage that works with millivolt systems. After
unplugging the unit, locate the jumper wire (J-3) on the bottom of the control panel. The two
screws should then be loosened and the jumper wire removed from the board. Next, the two
thermostat lead wires should be slipped into these openings and the screws tightened; the
jumper wire should be saved for future operation without a thermostat.
The unit will operate differently once the wall thermostat is connected – we recommend
the Control Board be set at “9” on Heat Range and Blower Speed while using the
thermostat. Refer to the section on “Start-up Procedure” for information on cold starts.
thermostat. Refer to the section on “Start-up Procedure” for information on cold starts.
AC-103, AC-103BN Lip Trim
There is one piece of J-Channel trim in this kit that snaps onto the ash apron lip of the
stove. Match the channel with the correct edge of the ash apron, then remove the protective
covering from the trim and force the piece onto the edge. Although it should stay in place,
stove cement can be used to secure it if necessary.
NOTE: For stoves manufactured prior to 2001, the part number for this kit is AC-101-PU.
stove. Match the channel with the correct edge of the ash apron, then remove the protective
covering from the trim and force the piece onto the edge. Although it should stay in place,
stove cement can be used to secure it if necessary.
NOTE: For stoves manufactured prior to 2001, the part number for this kit is AC-101-PU.
AC-106-P (SH-106-P), AC-106-PBN Window Trim
This trim can be attached by using the provided spring clip and some high temperature
silicone. Insert the tee end of the spring clip into the opening on the edge of the trim – this
will allow the clip to fall into the groove. The spring clip will hold well if it is placed on the
bottom edge of the trim. We also suggest that high temperature silicone be used on the
corners, to ensure the trim will stay in place.
silicone. Insert the tee end of the spring clip into the opening on the edge of the trim – this
will allow the clip to fall into the groove. The spring clip will hold well if it is placed on the
bottom edge of the trim. We also suggest that high temperature silicone be used on the
corners, to ensure the trim will stay in place.
Accessories can be ordered from the factory at:
(Parts orders ONLY) -- (800) 516-3636, or on our web site:
www.englandsstoveworks.com
.
Questions/Problems: Please call Customer Service at (800) 245-6489.