Roberts Radio RD-6 User Manual
The wire coloured BLUE must be connected to the terminal marked N or
coloured BLACK.
coloured BLACK.
The wire coloured BROWN must be connected to the terminal marked L or
coloured RED.
coloured RED.
Mains supply
The RD-6 will operate from a supply of AC 230 volts, 50Hz
only.
DO NOT cut off the mains plug from this equipment. If the plug fitted is
not suitable for the power points in your home or the cable is too short to
reach a power point, then obtain an appropriate safety approved extension
lead or adaptor. If in doubt consult your dealer.
not suitable for the power points in your home or the cable is too short to
reach a power point, then obtain an appropriate safety approved extension
lead or adaptor. If in doubt consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dispose of the
plug immediately to avoid a possible shock hazard by inadvertent connection
to the mains supply.
plug immediately to avoid a possible shock hazard by inadvertent connection
to the mains supply.
If this product is not supplied with a mains plug, or one has to be fitted, then
follow the instructions given below:
follow the instructions given below:
IMPORTANT. DO NOT make any connection to the larger terminal which
is marked with the letter E or by the safety earth symbol
or coloured
Green or Green-and-yellow.
The wires in the mains lead are coloured in accordance with the following
codes :-
codes :-
BLUE - NEUTRAL BROWN - LIVE
Fuse
When replacing the fuse only a 3A ASTA approved to BS1362 type should
be used and be sure to re-fit the fuse cover.
be used and be sure to re-fit the fuse cover.
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.
Replacement fuse holders are available from Roberts Radio Technical
Services at the address shown on the rear of this manual.
Services at the address shown on the rear of this manual.
21
rd-6 instruction book.pmd
2/26/2004, 8:54 AM
22