Roberts Radio exprssion User Manual

1.  Carefully extend the telescopic aerial fully.

2. Press 

the 

On/Off button to switch on your radio.

3. Press 

the 

DAB/FM button to select the FM band.

4.  Press and immediately release the Auto tune button, your radio will 

scan in an upwards direction (low frequency to high frequency) and 
stop automatically when it fi nds a station of suffi cient strength.

5.  After a few seconds the display will update. The display will show the 

frequency of the signal found. If the signal is strong enough and there 
is RDS data present then the radio will display the station name.

6.  To fi nd other stations, press and release the Auto tune button as 

before.

7.  To scan the FM band in a downwards direction (high frequency to low 

frequency) press and hold down the Auto tune button for 2 seconds 
and then release.

8.  When the waveband end is reached your radio will recommence tuning 

from the opposite waveband end.

9. Adjust 

the 

Volume control to the required setting.

The use of radio station presets for selecting your preferred radio stations 
is described on page 17.

3

2

4-7

9

If you fi nd that an FM broadcast has a lot of background hiss, this may 
often be reduced by setting the radio into Mono reception mode for the 
current FM station. Please refer to the section "Stereo / Mono setting - FM" 
on page 18 for further details.