Intel X5260 AT80573KJ0936M Data Sheet

69

D[63:0]#

I/O

D[63:0]# (Data) are the data signals. These signals provide a 64-bit 

data path between the processor FSB agents, and must connect the 

appropriate pins on all such agents. The data driver asserts DRDY# to 

indicate a valid data transfer.
D[63:0]# are quad-pumped signals, and will thus be driven four 

times in a common clock period. D[63:0]# are latched off the falling 

edge of both DSTBP[3:0]# and DSTBN[3:0]#. Each group of 16 data 

signals correspond to a pair of one DSTBP# and one DSTBN#. The 

following table shows the grouping of data signals to strobes and 

DBI#.

Furthermore, the DBI# signals determine the polarity of the data 

signals. Each group of 16 data signals corresponds to one DBI# 

signal. When the DBI# signal is active, the corresponding data group 

is inverted and therefore sampled active high. 

3

DBI[3:0]#

I/O

DBI[3:0]# (Data Bus Inversion) are source synchronous and indicate 

the polarity of the D[63:0]# signals. The DBI[3:0]# signals are 

activated when the data on the data bus is inverted. If more than half 

the data bits, within, within a 16-bit group, would have been asserted 

electronically low, the bus agent may invert the data bus signals for 

that particular sub-phase for that 16-bit group.

3

DBR#

O

DBR# is used only in systems where no debug port connector is 

implemented on the system board. DBR# is used by a debug port 

interposer so that an in-target probe can drive system reset. If a 

debug port connector is implemented in the system, DBR# is a no-

connect on the Dual-Core Intel® Xeon® Processor 5200 Series 

package. DBR# is not a processor signal.

DBSY#

I/O

DBSY# (Data Bus Busy) is asserted by the agent responsible for 

driving data on the processor FSB to indicate that the data bus is in 

use. The data bus is released after DBSY# is deasserted. This signal 

must connect the appropriate pins on all processor FSB agents.

3

DEFER#

I

DEFER# is asserted by an agent to indicate that a transaction cannot 

be guaranteed in-order completion. Assertion of DEFER# is normally 

the responsibility of the addressed memory or I/O agent. This signal 

must connect the appropriate pins of all processor FSB agents.

3

DP[3:0]#

I/O

DP[3:0]# (Data Parity) provide parity protection for the D[63:0]# 

signals. They are driven by the agent responsible for driving 

D[63:0]#, and must connect the appropriate pins of all processor 

FSB agents.

3

D[15:0]#

0

0

D[31:16]#

1

1

D[47:32]#

2

2

D[63:48]#

3

3

DBI[3:0] Assignment to Data Bus 

DBI0#

D[15:0]#

DBI1#

D[31:16]#

DBI2#

D[47:32]#

DBI3#

D[63:48]#