Chief Manufacturing CM2 User Manual
Installation Instructions
CM2
21
Address Description:
Multiple Chief devices can be used on the same network by setting each device to a different address.
Note: All units ship with a default address of 0
Address Table:
Addresses are set using dipswitches located next to power inlet on mount.
(See figure 32)
Status Table:
Status is a 4 character hex representation of a 16 bit value
Example:
Fully retracted, parameter changes disabled, no errors, not moving, in home position.
0, 0, 0, 0, 0, 0, 1, 0, 0, 0, 0, 0, 0, 0, 0, 1
Value returned as status: 0201 (hex)
Errors:
If no response message is received, the device does not exist on the network, or there was an error during message transmission
See Error Message Table
Error Message Table:
Switch # 6
Switch # 7
Switch # 8
Address
OFF
OFF
OFF
00
ON
OFF
OFF
01
OFF
ON
OFF
02
ON
ON
OFF
03
OFF
OFF
ON
04
ON
OFF
ON
05
OFF
ON
ON
06
ON
ON
ON
07
Bit
1
0
Description
0
TRUE
FALSE
In Home Position?
1
TRUE
FALSE
Move in Progress?
2
TRUE
FALSE
Network Operation in Progress?
3
TRUE
FALSE
Parameter Changes Enabled?
4
TRUE
FALSE
Network Command Error?
5
-
-
Not Used - Permanently @ 0
6
-
-
Not Used - Permanently @ 0
7
-
-
Not Used - Permanently @ 0
8
TRUE
FALSE
At Extend Limit
9
TRUE
FALSE
At Retract Limit
10
-
-
Not Used - Permanently @ 0
11
-
-
Not Used - Permanently @ 0
12
-
-
Not Used - Permanently @ 0
13
-
-
Not Used - Permanently @ 0
14
-
-
Not Used - Permanently @ 0
15
-
-
Not Used - Permanently @ 0
0x01
Command Not Supported
Returned when a device does not support the command sent
0x02 Index
Error
Returned when the index value sent is out or range for the device
0x03
Value Error
Returned when the data value sent is out of range for the device
0x04 Message Length Error
Returned when the length of the command message is incorrect for the command code
0x05 Write Protect Error
Returned when parameter changes are attempted without first enabling parameter changes