DMP Electronics XR2400F User Manual

15

User Code Level: 8 and above.

Your system may be programmed to allow a Fire Drill. The Fire Drill
is used to test the fire bells, horns, and other notification appliances
in your system. The Fire Drill turns on your system bell circuit, but
does not send a message to the central station.

1. Access the User Menu.

2. Press COMMAND until the FIRE DRILL? displays. Press any

SELECT key.

3. SURE?  YES  NO is displayed.

4. Press the SELECT key under YES to start the Fire Drill test.

1. Enter your code and press COMMAND to end the Fire Drill.

2. The Fire Drill test will automatically end with an ALARM SILENCE

or the programmed Bell Cutoff time.

The DRILL function key can be used after the keyswitch has been
turned to the “Enable” position.

Press the DRILL function key.  The display will show SURE? YES
NO.  Press YES to begin the fire drill.

The fire drill will automatically end after the programmed Bell Cutoff
time.

System Monitor Event Types - There are 2 event types:

TBL - Trouble

RST - Restore

System Monitor Event Names - There are 5 system monitors:

POWER - AC power to panel

BATTERY - On panel

LINE 1 - Phone line number 1

LINE 2 - Phone line number 2

TAMPER - On panel box

User Code Level: 8 and above.

Function: Allows you to send a Request for Service message to the
central station when there is a problem on your system.

After the Display Events function and if this feature is programmed for
your user code, you will see SERVICE REQUEST? displayed in the
User Menu. If you would like to send a Request for Service report to
the central station, press any top row SELECT key while SERVICE
REQUEST? is displayed. After the Request for Service report is sent,
REQUEST MADE is displayed for four seconds. Note: This function
is only displayed if it is enabled on your system and the user code has
authority.