DMP Electronics XR2400F User Manual
3
User Options Menu
Press and hold the ARROW and COMMAND keys for about two
seconds. The display shows SET BRIGHTNESS. Use the left SELECT
key to lower the display brightness. Use the right SELECT key to
increase the display brightness. Press COMMAND.
seconds. The display shows SET BRIGHTNESS. Use the left SELECT
key to lower the display brightness. Use the right SELECT key to
increase the display brightness. Press COMMAND.
At SET TONE, use the left SELECT key to lower the keyboard tone.
Use the right SELECT key to raise the tone. Press COMMAND.
Use the right SELECT key to raise the tone. Press COMMAND.
At SET VOLUME LEVEL, use the left SELECT key to lower the
keyboard volume. Use the right SELECT key to raise the volume.
Press COMMAND.
keyboard volume. Use the right SELECT key to raise the volume.
Press COMMAND.
At MODEL NUMBER, the model number of the keyboard is displayed.
Press the ARROW key to exit out of the User Options menu.
Press the ARROW key to exit out of the User Options menu.
Four Function Keys
The Fire Command Center has been designed with four additional
keys on the left side of the keypad. After turning the keyswitch, you
can quickly perform vital functions using these four keys.
keys on the left side of the keypad. After turning the keyswitch, you
can quickly perform vital functions using these four keys.
SILENCE Key
Pressing the SILENCE key will silence the alarm bells.
RESET Key
Pressing the RESET key will perform a sensor reset and silence the
alarm bells.
alarm bells.
TEST Key
Pressing the TEST key will perform a system test.
DRILL Key
Pressing the DRILL key will display a prompt “SURE? YES NO”.
Press YES to begin the fire drill. Press NO to return to the status list.
Press YES to begin the fire drill. Press NO to return to the status list.
Introduction
Remote Fire Command Center
The XR2400F Addressable Fire Alarm Control Panel can be expanded
by adding a Remote Fire Command Center. With the Remote Fire
Command Center, user’s can access the User Menu and perform the
same functions as the Fire Command Center in the panel. All of the
keys, except the four function keys, can be used at any time without
turning the keyswitch.
by adding a Remote Fire Command Center. With the Remote Fire
Command Center, user’s can access the User Menu and perform the
same functions as the Fire Command Center in the panel. All of the
keys, except the four function keys, can be used at any time without
turning the keyswitch.
The four function keys can only be used when the keyswitch has been
turned to the enable position. These keys are the same as those on
the Fire Command Center in the panel. Both keyboards also have the
same displays and prompts. Follow the same instructions for using
both keyboards.
turned to the enable position. These keys are the same as those on
the Fire Command Center in the panel. Both keyboards also have the
same displays and prompts. Follow the same instructions for using
both keyboards.
Below is an illustration of the Remote Fire Command Center showing
the keyswitch lock that enables the four function keys.
the keyswitch lock that enables the four function keys.
Keyswitch
Function
Keys
Keys
LCD Display
Data Entry Keys
ARROW Key
COMMAND Key
Status LEDs
SELECT keys