American Standard T373.521 User Manual

Remove CARTRIDGE (1) by removing CARTRIDGE SCREWS (2).

  

 

Remove 

three 

SCREWS (3) from FIXATION RING (4)

 

   and pull out PRESSURE BALANCING (5) unit.

Clean SEALS (9) on base of CARTRIDGE (1). Check base of PRESSURE

  

 

BALANCING 

UNIT (5) and clean O-RINGS (6). Remove CAPS (7) and check

 

   O-RINGS on inside of CAPS (7) for debris. Clean inside sealing surfaces of VALVE BODY (8).

Re-assemble PRESSURE BALANCING UNIT (5) and CARTRIDGE (1). Tighten all screws.

Turn on water supply and see above for installing TRIM and HANDLE.

 

   If it still leaks, replace pressure balancing unit (M952100-0070A).

Remove PRESSURE BALANCE UNIT (5).

Remove CAPS (7) and clean valve thoroughly.

Examine balancing unit and check condition of O-ring on end of piston. Piston should move back and forth.

 

   Order Repair Part M952100-0070A if balancing unit is defective. Replace CAPS (7) and install PRESSURE    

 

   BALANCE UNIT (5). Make sure inlets line up with two holes in bottom of casting.

 

   Top flange should butt-up against top of casting.

When finished tiling the wall, remove PLASTER GUARD (A)

 

   and turn off water supply.

Install STEM ADAPTER (1) onto valve stem with ADAPTER

  

 

SCREW 

(2).

Push CAP (3) over VALVE CARTRIDGE (4).

Mount ESCUTCHEON (5) to valve body with SCREWS (6).

Push DIAL PLATE (7) over CAP (3) and into the four alignment

 

   holes in ESCUTCHEON (5).

Remove PIPE CAP (8) and PIPE CAP (9) from shower pipe and tub filler

  

 

pipe.

Install SHOWER ARM (10), SHOWER HEAD (11) and TUB

 

   FILLER SPOUT (12) by threading onto pipe nipples using teflon

 

   tape or pipe sealant.

Align HANDLE (13, 14) and push onto STEM ADAPTER (1).

        Tighten set screw in HANDLE (13, 14) securley with HEX
        WRENCH (15) supplied.

Remove HANDLE and TRIM. See step one and reverse assembly
procedure.

HANDLE

and TRIM

(4) ALIGNMENT

HOLES FOR

DIAL PLATE

M 9 6 8 2 8 5   R e v.   1 . 1