American Standard 7274.525 User Manual

COMBO VALVE TURRET FITTINGS
AND VANDAL RESISTANT

For vandal resistant fitting only, a pin hole will be need to be drilled into the deck offset from the mounting shank hole.
Note: For vandal resistant models it is important to obtain the rough-in drawing for the particular model. The
drawing illustrates exact size and positioning of the offset hole. Drill a 5/16" [8mm] dia. hole 1/2" [13mm] deep
in mounting surface, per roughing-in dimensions for vandal resistant pin.

Note: 7274.515/525 require inlet shank M962323-0070A for installation
and must be ordered separately.

Apply

putty

to underside of turret body to assure a good seal and level fit.

If installing a vandal resistant fitting, align pin with pin hole in mounting surface.

Place body shank through hole in deck and assemble steel washer and
lock nut. Tighten securely.

Pipe to correct service to complete installation.

After installation is complete turn service on and check all connections
for leaks.

TOOLS AND SUPPLIES REQUIRED

Adjustable Wrench

Teflon Tape

Drill

Plumbers' Putty or
Caulking

Product names listed herein are trademarks of American Standard Inc. © A m e r i c a n S t a n d a r d I n c . 2 0 0 4

HOTLINE FOR HELP

For toll-free information and answers to your questions, call:

1 (800) 442-1902

Weekdays

8:00 to 7:00 p.m. Eastern Time

CANADA

1-800-387-0369 (TORONTO 1-905-306-1093)

PUTTY

LOCK NUT

STEEL WASHER

M962323-0070A

3/8" NPT X 4-3/4"
INLET SHANK WITH

LOCKNUT & WASHER

VANDAL RESISTANT PIN
ON VANDAL RESISTANT
FITTINGS ONLY

OFFSET HOLE FOR
VANDAL RESISTANT PIN

TURRET

BODY

Channel Locks

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR

WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,

ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A

COARSE SURFACE.

M 9 6 8 4 8 6

IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO FITTING INSTALLATION.