American Standard 9422.020 User Manual

7 3 0 8 0 4 - 1 0 0

-   2   -

Thread the two legs with tapered upper ends into the threaded 
holes at the front of the cabinet.  Thread the remaining legs 
into the two holes at the rear of the cabinet.  Hand-tighten 
each of the four legs.

Note:  If replacing an existing sink be certain to shut 
off water supply before removing old sink.  If installing 
in a new bathroom follow rough-in diagram to locate 
rough supply, waste lines.

Provide suitable reinforcement behind finished wall for 
sink hanger screws.  For an installed sink height of 
36", center the reinforcement 29" above the floor.

1) Move washstand into approximate position near the wall.

2) Place sink on washstand, aligning the tapered ends of the front legs with 

the recesses in the underside of the front of the sink.

3) Place a level on the cabinet and use the four independently adjustable 

washstand feet to level the assembly both side-to-side and front-to-back.

4) Place the level on the sink.  If adjustment is required, either front-to-back or 

side-to-side, remove the sink, place one or more of the adhesive-backed 
cushions on the top surfaces of any of the legs as appropriate, and 
replace the sink to verify.

5) Move the assembly into contact with the wall.

6) With a pencil, mark through the center of the two mounting holes found on 

the back of the sink. See VIEW "A".

7) Move the assembly well clear of the wall.

8) Drill two pilot holes at the center marks using a 1/4" bit.  Bore in 1" deep.

9) Thread the two 5/16" headless hanger screws into the pilot holes leaving

    1-7/8" thread exposed in front of the wall.

C/L of 2 x 8
Support
and Bracket

Finished
Floor

29"

Hanger Screw,
Washer & Nut

Lavatory

Front Leg
of Washstand

Following manufacturer's instructions, install faucet and 
drain assembly (not included) in sink.  Be certain to apply 
a bead of sealing putty on the underside of the drain to 
ensure a watertight seal between the sink and the drain.  
Remove excess putty immediately after tightening drain.

Move the assembly back toward the wall, guiding the 
sink over the two headless hanger screws.  Place 
washers over studs and firmly hand-tighten nuts onto 
each.

Feet are
adjustable

With lavatory in

place mark the

two mounting

hole locations.

Front

Back