Toro 100 User Manual

• Controls up to 200 stations for the 

Stand-Alone model

• Input power supply

100 VAC, 50/60Hz
120 VAC, 50/60Hz
240 VAC, 50/60Hz

• TDC output voltage: 40 VAC max.

• TDC output power: 98VA max.

• Storage temperature:  -30C–60C

• Operating temperature: 0–60C

• Cabinet Type: Non-corrosive, lockable wall mount, 

indoor/outdoor installation

• Six 25.4mm conduit openings and one 38mm conduit opening

Selecting the proper installation site for the 2-wire decoder is essential to safe 
and reliable operation. The 2-wire decoder features a weather resistant cabinet designed for indoor or outdoor installation.

The TDC should be installed on a vertical wall or other sturdy structure near 
a grounded power source. Select a location that shades the controller during the
hottest hours of the day and provides as much protection from direct sunlight,
rain, wind and snow as possible. DO NOT mount the controller where it is
exposed to direct spray from the irrigation system.

For easy operation and better view of the display (Stand-alone model), 
install the TDC so that the display is at or slightly below eye level.

Step 1 – Drill two pilot holes 15.25cm apart for the top keyholes of the

controller cabinet.

Step 2 – Install the top screws leaving approximately 5–6mm of exposed

screw to accommodate 
the cabinet.

If mounting the cabinet on dry wall or

masonry, install the appropriate type of screw
anchors or fasteners to ensure secure installation. 

Step 3 – Hang the cabinet using the top keyhole slots. 

See Figure 1.

Step 4 – Open the cabinet door and install the bottom two

screws to 
secure the cabinet.