American Standard 2908.222 User Manual

With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate both HANDLES (1) to flush water
lines thoroughly.

Replace AERATOR (3).

Operate POP-UP KNOB (5) and fill Sink with water.
Check that DRAIN STOPPER (4) makes a good seal
and retains water in Sink. If STOPPER (4)  does not 
seal properly, please refer to “Troubleshooting Guide” 
in these instructions.

Release POP-UP KNOB (5) down and check all 
drain connections and "P" trap for leaks.     
Tighten if necessary.

U S 6 0 3 8 5   R e v.   1 . 2

TOP

SPLINE END

DOWN

Push INDEX CAP (6) 

in hole of LEVER BALL (4).

Secure LEVER BALL (4)

with HANDLE SCREW (5).

Find correct position of 

HANDLE (4) by adjusting 

male teeth on ADAPTER (1) 

to female teeth in 

LEVER BALL (4).

Thread HANDLE BASE (3) onto

VALVE ESCUTCHEON (7)

Push LEVER BALL (4) onto

ADAPTER (1).

Push ADAPTER (1) on VALVE

STEM (2), so that the hole of the

ADAPTER (1) without spline is 

facing up.

Thread PORCELIAN LEVER HANDLE (2) counter-clockwise

and remove INDEX BUTTON with MOUNTING ROD ASSEMBLY (1).

Insert MOUNTING ROD ASSEMBLY (1) into METAL HANDLE (3)

and HANDLE COLLAR (4).

 

Thread HANDLE ASSEMBLY (6) into ball of HANDLE BASE (5)

and tighten. 

Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90  and replace.
Replace SPRING CLIP (1).
Replace ADAPTER, HANDLE, SCREW, and INSERT.

90 

Replace Spray and operate handles several times from
OFF to ON position. Do not force, handles turn only 90˚.

Spray may accumulate dirt causing distorted and reduced
water flow. Remove spray and rinse clean.