Marantz SR6005 User Manual
72
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
SVENSKA
Operating learn function
• If the AV device is not a Marantz device, or if the device does not
operate even when the preset code is registered, use the learning
function. Remote codes for different devices can be remembered
for use by the Marantz remote control included with this device.
function. Remote codes for different devices can be remembered
for use by the Marantz remote control included with this device.
• This remote control unit is capable of learning around 160 codes.
Remembering remote control codes from
other devices
1
Place the Marantz remote control and remote control
from the other device approximately 5 cm apart,
with the remote control signal transmission sections
facing each other.
5 cm
2
Press and hold down
SET
and
SOURCE SEL
until the LEARN
indicator blinks.
3
Press input source select buttons
to select the input source.
The input source is shown in the remote
control display.
control display.
4
Select the button to be learned.
LEARN indicator lights up.
5
Press and hold the button that you want to register
on the other remote control until “OK” is displayed
on the Marantz remote control display.
• If “NG” is shown on the remote control display, perform step 5
again. If “NG” is shown again on the remote control display, the
remote control may not be able to learn the code correctly. In this
case, use the specialized remote control for the device.
remote control may not be able to learn the code correctly. In this
case, use the specialized remote control for the device.
• If the remote control memory becomes full, “FULL” is shown
on the remote control display. If you want to learn the code, you
should erase other learned button.
should erase other learned button.
6
Repeat steps 4 and 5 to learn other buttons for the
same input source.
7
Repeat steps 3 to 6 to learn other input sources.
8
When programming of the remote control unit is
completed, press
SET
.
The LEARN display disappears, and the remote control unit
exits learn mode.
exits learn mode.
NOTE
• The learning function is unavailable for all
SOURCE ON/OFF
,
MACRO
and
HDMI
in any mode.
• The learning function is unavailable for all buttons in TUNER mode,
AMP mode, NET/USB mode and M-XP mode.
• The learning procedure does not operate correctly if the batteries
have become worn.
• If no buttons are pressed for approximately 1 minutes while in the
LEARN mode, the remote control unit automatically exits from the
LEARN mode.
LEARN mode.
n
Set top box for satellite (SAT) operation
Operation buttons
Function
SOURCE ON/OFF
Power on/standby
CHANNEL +, –
Switch channels (up/down)
uio
p
Cursor operation
ENTER
Enter
0 – 9
Channel selection
CLR
Clear the inputting
TV POWER
TV power on/standby
(Default : Marantz)
TV INPUT
Switch TV input
(Default : Marantz)
Operating components