Panasonic SC-HTB10 User Manual
22
Components
The images shown in this installation instructions are for illustrative purpose only.
Check the supplied components before starting.
Check the supplied components before starting.
Commercially available components (not supplied)
≥ Screws for wall mounting
≥ Fall prevention cord
≥ Screws for wall mounting
≥ Fall prevention cord
≥ Screws to attach fall prevention cord to wall
≥ Use commercially available screws with a nominal diameter of ‰4.0 mm that are suited to the wall material (wood, steel frame,
concrete etc.) you are attaching the wall mount brackets to.
≥ Product numbers correct as of April 2010. These may be subject to change.
Installation procedure
Never use any other method than specified to install
Preparation
≥ To prevent damage or scratches, lay down a soft
cloth and perform the assembly on it.
≥ Keep the screws out of reach of children to
prevent swallowing.
≥ Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1
On the rear of the unit:
Place the wall mount bracket by
aligning the holes in the wall mount
bracket with the projecting parts A.
aligning the holes in the wall mount
bracket with the projecting parts A.
2
Screw the wall mount bracket firmly
into place.
into place.
≥ Screw tightening torque: 80 N0cm to 120
N0cm.
≥ Repeat the steps above when installing the
second wall mount bracket.
∏ 2 Wall mount brackets
∏ 2 Screws
∏ 2 Lock pins
∏
AC mains lead
(Australia and New Zealand)
(Australia and New Zealand)
(Saudi Arabia and Kuwait)
(Others)
Attaching the wall mount brackets
SCHTB10EGGNGS_RQTX1160-B.book Page 22 Thursday, June 10, 2010 3:19 PM