Panasonic SC-HTB65 User Manual

RQT9763

Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the 
solutions indicated in the following guide do not solve the problem, refer to “Customer Services Directory (United States 
and Puerto Rico)” on page 26 if you reside in the U.S.A. or Puerto Rico, or refer to “WARRANTY SERVICE” on page 27 
if you reside in Canada.

≥ Insert the AC power supply cord securely. (> 17)
≥ After turning the main unit on, if the indicators blink and 

the main unit immediately turns off, unplug the AC 
power supply cord and consult your dealer.

≥ The battery is depleted. Replace it with a new one. 

(> 7)

≥ It is possible that the insulation sheet has not been 

removed. Remove the insulation sheet. (> 7)

≥ It may be necessary to set the code of the remote 

control again after changing the battery of the remote 
control. (> 21)

≥ Use the remote control within the correct operation 

range. (> 7)

Remove the AC power supply cord and consult your 
dealer. If there are any other indicators blinking, be sure to 
inform your dealer about the blinking indicators.

The main unit will automatically switch to standby mode 
when no signal is input and no operation is performed for 
approx. 30 minutes. (> 17)

Change the speaker angle settings manually so that the 
indicator color matches the tilt.
1

Press and hold [INPUT SELECTOR] on the main unit 
for more than 4 sec.

≥ The speaker angle indicator blinks.

2

While the indicator is blinking, press [INPUT 
SELECTOR] on the main unit repeatedly to match 
the indicator color with the placement method.

≥ Refer to “Step 1  Selecting the placement method” 

(> 8) for the relation between color and tilt.

Check the Bluetooth

®

 device condition.

≥ The pairing of the device was unsuccessful or the 

registration has been replaced. Try pairing the device 
again. (> 17)

≥ This system might be connected to a different device. 

Disconnect the other device and try pairing the device 
again.

For some built-in Bluetooth

®

 devices, you have to set the 

audio output to “SC-HTB70” or “SC-HTB65” manually. 
Read the operating instructions for the device for details.

≥ The device is out of the 10 m (33 ft) communication 

range. Bring the Bluetooth

®

 

device closer to the main 

unit.

≥ Remove any obstacle between the main unit and the 

device.

≥ Other devices that use the 2.4 GHz frequency band 

(wireless router, microwaves, cordless phones, etc.) are 
interfering. Bring the Bluetooth

®

 device closer to the 

main unit and distance it from the other devices.

≥ Select “MODE1” for stable communication. (> 20)

To return to the factory preset.
While the main unit is on, press [Í/I] on the main 
unit for more than 4 sec.
(All the indicators will blink twice when this 
system is reset.)
If this system does not operate as expected, 
returning the settings to the factory preset 
may solve the problem.
≥ The remote control code will return to “1” when 

this system is returned to the factory preset. To 

change the remote control code, refer to page 

21.

SC-HTB65_70PPC_RQT9763-1P.book  Page 22  Thursday, February 7, 2013  4:24 PM