Panasonic SC-PT550 User Manual

RQT8043

RQTX0038

7 Progressive video 

•  This problem is caused by the editing method or material used on DVD-Video, 

but should be corrected if you use interlaced output. Set “Video Output Mode” in 
Picture Menu to “480i” or “576i”. (Alternatively, press and hold [CANCEL] to switch 
to “480i” or “576i”.)

•  Disable the HDMI AV OUT connection and use other video connections. Make the 

settings in the following order:

1  Set “Video Mode” in the “HDMI” tab to “Off”.
2  Set “Video Output Mode” in Picture Menu to “480i” or “576i”. (Alternatively, press 

and hold [CANCEL] to switch to “480i” or “576i”.)

24

28
24

•  Select “480p” or “576p” in “Video Output Mode” in Picture Menu.
•  The unit’s VIDEO OUT or SCART (AV) terminal outputs an interlaced signal even if 

“PRG” is displayed.

24
13

•  When HDMI or progressive output is on, closed captions will not be displayed.

—

7 Unit displays

•  Select “Bright” in “FL Dimmer” in the “Others” tab.

29

•  You inserted a disc the unit cannot play; insert one it can.
•  You inserted a blank disc.
•  You inserted a disc that has not been fi nalized.

15

—
—

•  You have not inserted a disc; insert one.
•  You have not inserted the disc correctly; insert it correctly.

—

18

•  The USB device is drawing too much power. Switch to DVD/CD mode, remove the 

USB and turn the unit off.

—

•  Check and correct the speaker cable connections.
  If this does not fi x the problem, consult the dealer.

12

•  There is a power supply problem. Consult the dealer.

—

•  Disc may be dirty. Wipe it clean.

30

•  Incorrect operation performed. Read the instructions and try again.

—

& &”

& & &”

& stands for a number.

•  Trouble may have occurred. The numbers following “H” and “F” depend on the 

status of the unit. Turn the unit off and then back on. Alternatively, turn the unit off, 
disconnect the AC mains lead, and then reconnect it.

•  If the service numbers fail to clear, note the service number and contact a qualifi ed 

service person.

—

—

•  There is no link between the main unit and the wireless accessory. Check that the 

wireless accessory is plugged into the mains socket.

•  Ensure that the digital transmitter is fully inserted into the slot of the main unit.

11

11

•  Down-mixing is the process of remixing the multiple-channel audio found on some 

discs into two-channels. The disc contains single-channel or multiple-channel 
signals which may not be reproduced authentically.

—

&”

& stands for a number.
The actual number following “U70” 
will depend on the state of the main 
unit.

•  The HDMI connection acts unusually.
  – The connected equipment is not HDMI-compatible.
  – The HDMI cable is too long.
  – The HDMI cable is damaged.

 

—
—
—

•  Match the modes on the main unit and remote control. Depending on the number 

being displayed (“1” or “2”), press and hold [ENTER] and the corresponding 
numbered button ([1] or [2]) for at least 2 seconds.

40

 

•  MIC not inserted. Check whether MIC is plugged in properly in to the “SETUP MIC” 

jack.

38

 

•  Excessive ambient noise in the room.

—

 

•  Center output not within the proper range. Check for proper connection and adjust 

the position of the center speaker.

•  Headphone inserted. Remove the headphone connected.
•  Auto speaker setup turned off abnormally.
•  DVD is not in the STOP condition. Remove all discs loaded.
•  Karaoke Mic inserted. Remove the Karaoke Mic.
•  Volume is muted. Turn off the mute.

—

16

—
—
—

17

7 USB

•  The USB drive format or its contents is/are not compatible with the system.
•  The USB host function of this product may not work with some USB devices.
•  USB devices with storage capacity of more than 32 GB  may not work in some 

instances.

37

—
—

•  Large fi le size or high memory USB device takes longer time to read and display 

on the TV.

—

RQTX0038-3B.indd   43

RQTX0038-3B.indd   43

4/2/07   1:46:24 PM

4/2/07   1:46:24 PM