Panasonic PT-DZ16KD User Manual
Chapter 3 Basic Operations — Switching on/off the projector
48 - ENGLISH
f
The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lit in red). Refer to “Power consumption”
(x page 170) for the power consumption.
f
The power indicator <ON (G)/STANDBY (R)> will blink in green if the projector receives a remote control signal.
f
The power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the shutter is closed.
f
If the power indicator <ON (G)/STANDBY (R)> is blinking in red, consult your dealer.
Switching on the projector
Install the projection lens before switching on the projector.
Remove the lens cover first.
Remove the lens cover first.
2)
4)
4)
3)
1)
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
2) Connect the power plug to an outlet.
f
(AC 200 V - 240 V, 50 Hz/60 Hz)
3) Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f
The power indicator <ON (G)/STANDBY (R)> lights in red, and the projector enters the standby mode.
4) Press the power on <b> button.
f
The power indicator <ON (G)/STANDBY (R)> lights in green and the image is soon projected on the screen.
Attention
f
Using the projector while the lens cover is attached may cause the device to heat up and result in a fire.
Note
f
If the projector is switched on at around 0 °C (32 °F), a warm-up period of up to 20 minutes may be necessary until an image is displayed.
The temperature indicator <TEMP> lights during the warm-up period. When the warm-up is completed, the temperature indicator <TEMP>
turns off and the projection starts. Refer to “When an indicator lights up” (x page 141) for the indicator status display.
f
If the operating environment temperature is low and warm-up takes more than 20 minutes, the projector will judge that a problem has
occurred and the power will automatically be set to standby mode. If this happens, increase the operating environment temperature to 0 °C
(32 °F) or higher, turn off the main power, and then switch on the projector again.
f
If the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longer before the projector starts
projecting after the power is turned on, compared with when [NORMAL] is set.