ONKYO 29344937 User Manual

71

With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.

Main: The main channel is output (default).

Sub: The sub channel is output.

M/S: Both the main and sub channels are output.

This setting determines which channel of a stereo multiplex source is output. Use it to select audio channels or 
languages with multiplex sources, multilingual TV broadcasts, and so on.

 L+R: Both the left and right channels are output (default).

L: Only the left channel is output.

R: Only the right channel is output.

This setting determines which channel is output when the Mono listening mode is used with a stereo source.

3-2. Dolby
These settings apply to only 2-channel stereo sources.
If you’re not using any surround back speakers, these settings apply to Dolby Pro Logic II, not Dolby Pro Logic IIx.

On: Panorama function on.

Off: Panorama function off (default).

With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx Music 
listening mode.

With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic IIx Music 
listening mode. Higher settings move the sound field backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much surround sound, move the sound field forward to improve 
the balance. Conversely, if the stereo image feels like it’s in mono, or there’s not enough surround sound, move 
it backward.

With this setting, you can adjust the width of the sound from the center speaker when using the Dolby Pro Logic 
IIx Music listening mode. Normally, if you’re using a center speaker, the center channel sound is output by only 
the center speaker. (If you’re not using a center speaker, the center channel sound will be distributed to the front 
left and right speakers to create a phantom center.) This setting controls the front left, right, and center mix, 
allowing you to adjust the weight of the center channel sound.

Auto:  If the source signal contains a Dolby EX flag, the Dolby EX listening mode is 

used.

Manual: You can select any available listening mode (default).

This setting determines how Dolby EX encoded signals are handled. This setting is unavailable if no surround 
back speakers are connected. This setting is effective with Dolby Digital, Dolby Digital Plus and Dolby TrueHD 
only.

Notes:
• If the “SurrBack” Setting is set to “None”, this setting cannot be selected (see page 68).
• If the “FrontH” setting is set to other than “None”, this setting is fixed at “Manual” (see page 68).