Rocketfish RF-RBWS02 User Manual
27
RF-RBKIT
To set up your remote control:
1
Remove the insulation sheet before using the remote control for the first
time.
2
Aim the remote control at the IR sensor on the front lens from a
maximum distance of 23 ft. (7 m) away and the maximum angle of +/- 30
degrees from the center line.
Controlling the volume
Each device in a Rocketboost network has its own means of
controlling volume output level.
There are three tiers of volume control in a Rocketboost network.
controlling volume output level.
There are three tiers of volume control in a Rocketboost network.
Controlling the device volume
To control the volume from the sender to all devices connected to receivers at the same
time:
time:
1
Set the 4-Channel Lock on the back of the sender to Enable.
2
Either press the DEVICE buttons on the remote control or turn the
volume knob on one of the receivers.
Note: After 4-channel lock is enabled on the sender, the two stereo channels
connected to the sender will no longer be switchable in the source list. For example, if
you press the
you press the
Source button on a receiver it will not pick up either channel. Therefore,
you should always connect to the correct sources with 4-channel lock disabled first,
then enable 4-channel lock.
then enable 4-channel lock.
To control the volume from the sender to an individual device connected to a receiver:
The volume of an individual device can be changed by adjusting the
volume on the receivers one by one.
The volume of an individual device can be changed by adjusting the
volume on the receivers one by one.
1
Set the 4-Channel Lock at the rear sender to Disable.
RF-RBKIT_09-0473_MAN_ENG_V1.fm Page 27 Thursday, August 27, 2009 6:44 PM