Rocketfish RF-RBWS02 User Manual

8

Standby LED

Turns red when the sender is in standby mode.

Power/Join 
button

Press to turn the sender on. Press and hold to initiate joining. Press again to go to 
standby. When the AC adapter is plugged in, the Sender automatically powers up.

Power/Join 
indicator

Lights steady in power-on mode (green when the Hub Enable switch is set to “Enable.” 
Blue when the Hub Enable switch is set to DISABLE)
Blinks quickly in joining mode.
Blinks slowly when the device is not part of a network or the hub is not powered.

HD A/B indicator Lights when the high definition function is activated.

HD A/B button

Press repeatedly to toggle between CD and HD audio link modes for input A and input 
B respectively. When the HD function is activated, the audio quality will be enhanced.

Source A/B 
button

Press to enable the source to be transmitted onto the network and press again to 
disable the source. The status will be shown on the indicator. Make sure your hooked 
up speaker outputs match the enabled source, sound will not be sent unless the inputs 
connected have a corresponding activated source.

Source A/B 
indicator

LED is illuminated steadily when a source is being transmitted. LED is off when no 
source is enabled. LED blinks for a short while when a receiver selects this source to 
listen to.

TM

1

5

4

10

8

7

2 3

9

6

RF-RBKIT_09-0473_MAN_ENG_V1.fm  Page 8  Thursday, August 27, 2009  6:44 PM