Sony LF-B1 User Manual

19

Read the “Dynamic DNS Terms-of-Use 
Agreement” included in the carton box. 
After reading the document, select the radio 
button and then click [Next].

When you click [Next], the information 
required for the Dynamic DNS is saved to 
the Base Station.

Follow the on-screen instructions to wait 
until the NETAV LED stops blinking 
(amber) and click [Next] when the NETAV 
LED turns off. 

z 

• The NETAV LED continues to blink for about 

1 minute before turning off. 

• If the NETAV LED turns on amber, check that 

the router and modem are turned on and the 
LAN cable is connected properly. 

• When the NETAV LED turns green, another 

device is connected by NetAV. Wait until the 
LED turns amber to perform this step.

• NetAV cannot be used via a proxy server.

Click [Check]. 

The setup is complete if [Success] appears in 
the [NetAV Check] page. 
If the test page does not appear, check the 
network connection. 

Click [Exit Setup].
Restart the Base Station. 
Close the browser. 

Read the instructions on the [NetAV Check] page 
and configure the necessary settings. 

The Base Station needs to be set up to use the 
NetAV function away from home. There are two 
setup types: [Easy Setup] and [Advanced Setup] 
(

1 page 35). [Easy Setup] requires the router to 

be UPnP compatible and the UPnP function of 
the router to be enabled. Refer to the operating 
instructions for your router and confirm the 
settings. 

If your router is not UPnP compatible, you prefer 
not to use the UPnP function of the router, or if 
you use the UPnP function but the setup is 
unsuccessful, port forwarding needs to be set on 
the router.

z 

• Setting port forwarding on the router requires a 

static IP address to be set in the [Internet 
Connection] frame of the [Advanced Setup] page for