Sony HT-K25 User Manual

GB

Attach the jack cover. Fasten the screws (not
supplied) to the wall at the same height 80 mm
apart. The screws should protrude by 5 to
6 mm.

Remove the seals covering the hanging holed.
Hang the control center on the screws. Push the
control center tightly against the wall.

• Use the screws that matches the wall material and

strength.

• Install the control center on a vertical and flat wall

where reinforcement is applied. Do not instal the
control center if the wall is not vertical, flat or
strong enough.

• Contact a screw shop or installer regarding the wall

material or screws to be used.

• After the control center has been used for long time

on the wall, the wall behind or above the control
center may discolor or peel off by radiation of heat
from the control center depending on the wall
material.

• Sony will refrain from any responsibility on the

accident or damage caused by improper installation,
lack of durability of the wall or screws improper
operation, natural calamity, etc.

• When you disconnect or connect the cords, take the

control center down from the wall.

After connecting the components, connect the
AC power cord of the subwoofer to a wall
outlet.

b

80 mm

5 to 6 mm

4.2 mm

9.2 mm