Sharp CD-SW200 User Manual

Page of 44
 
03/12/17
CD-SW200 _2-14.fm
 
12
 
CD-SW200
 
Preparation for Use
 
System connections (continued)
  
Antenna connection
 
Supplied FM antenna:
 
Connect the FM antenna wire to the FM 75 OHMS terminal and po-
sition the FM antenna wire in the direction where the strongest signal
can be received.
 
Supplied AM loop antenna:
 
Connect the AM loop antenna to the AM LOOP jack. Position the AM
loop antenna for optimum reception. Place the AM loop antenna on
a shelf, etc., or attach it to a stand or a wall with screws (not sup-
plied).
 
Note:
 
Placing the antenna on the unit or near the AC power cord may
cause noise pickup. Place the antenna away from the unit for better
reception.
 
Installing the AM loop antenna:
  
Speaker connection
 
FRONT SPEAKERS:
 
Connect the black wire to the FRONT SPEAKERS minus (-) terminal,
and the red wire to the FRONT SPEAKERS  plus (+) terminal.
 
SUBWOOFER:
 
1. Connect the black wire to the SUBWOOFER minus (-) terminal,   
    and the red wire with purple insulation tube to the SUBWOOFER
    plus (+) terminal.
2. Connect the subwoofer light-up wire to the SUBWOOFER    
    LIGHT-UP jack.
 
Caution:
 
< Assembling >
< Attaching to the wall >
 
Wall   Screws (not supplied)
ANTENNA
AM
LOOP
FM
75 OHMS
GND
  
Never mistake the FRONT SPEAKERS and the SUBWOOFER 
terminals. The unit or the speakers may be damaged.
  
If you use other speakers with an impedance lower than that 
specified, the unit may be damaged. Front speakers: 6 ohms, 
Subwoofer: 12 ohms.
  
Do not mistake the right and the left 
channels. The right speaker is the one on the 
right side when you face the unit.
  
Do not let the bare speaker wires touch 
each other.
  
Do not stand or sit on the speakers. You may 
be injured.
  
Do not allow any objects to fall into or to be 
placed in the bass reflex duct.
 
Incorrect
Black
Red
Red
Black
SUBWOOFER