Tascam SN29401376 User Manual

While Audyssey 2EQ

®

 Room Correction and Speaker 

Setup is in progress, one of the error messages below may 
appear.

 

The options are:

`

Retry:

Try again.

`

Cancel:

Cancel Audyssey 2EQ Room Correction and Speaker 
Setup.

The background noise is too loud. Remove the source of 
the noise and try again.

The number of speakers detected was different from that 
of the first measurement. Check the speaker connection.

This message appears if saving fails. Try saving again. If 
this message appears after 2 or 3 attempts, contact the 
dealer from whom you purchased this unit.

This message appears if a speaker is not detected. “No” 
means that no speaker was detected.

• See “Speaker Configuration” for appropriate settings 

(

➔ page 11).

You can manually make changes to the settings found 
during Audyssey 2EQ Room Correction and Speaker 
Setup.
See also:
• “Speaker Configuration” (

• “Speaker Distance” (

• “Level Calibration” (

➔ page 51)

If you’re using a powered subwoofer and it outputs very 
low-frequency sound at a low volume level, it may not be 
detected by Audyssey 2EQ Room Correction and Speaker 
Setup.
If the “Subwoofer” appears on the “Review Speaker 
Configuration” screen as “No”, increase the subwoofer’s 
volume to the half-way point, set it to its highest crossover 
frequency, and then try running Audyssey 2EQ Room 
Correction and Speaker Setup again. Note that if the 
volume is set too high and the sound distorts, detection 
issues may occur, so use an appropriate volume level. If the 
subwoofer has a low-pass filter switch, set it to Off or 
Direct. Refer to your subwoofer’s instruction manual for 
details.

Error message