Tascam SN29401376 User Manual

Replacement and mounting of an AC plug on the power 
supply cord of this unit should be performed only by 
qualified service personnel.

The wires in the mains lead are coloured in accordance 
with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this 
apparatus may not correspond with the coloured markings 
identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the 
terminal which is marked with the letter N or coloured 
black.
The wire which is coloured brown must be connected to 
the terminal which is marked with the letter L or coloured 
red.

The plug is fitted with an appropriate fuse. If the fuse needs 
to be replaced, the replacement fuse must approved by 
ASTA or BSI to BS1362 and have the same ampere rating 
as that indicated on the plug. Check for the ASTA mark or 
the BSI mark on the body of the fuse.
If the power cord’s plug is not suitable for your socket 
outlets, cut it off and fit a suitable plug. Fit a suitable fuse 
in the plug.

Make sure you have the following accessories:

*

In catalogs and on packaging, the letter at the end of the product 
name indicates the color. Specifications and operations are the 
same regardless of color. 

■

• If the remote controller doesn’t work reliably, try replacing the 

batteries.

• Don’t mix new and old batteries or different types of batteries.
• If you intend not to use the remote controller for a long time, 

remove the batteries to prevent damage from leakage or 
corrosion.

• Remove expired batteries as soon as possible to prevent damage 

from leakage or corrosion.

• Be sure to insert the batteries with correct positive (+) and 

negative (–) orientations.

• If the batteries leak, wipe away the leakage inside the battery 

compartment and replace the batteries with new ones.

• Do not heat or disassemble batteries.
• Do not carry or store batteries with other metallic objects. The 

batteries could short circuit, leak or explode.

• Never recharge a battery unless it is confirmed to be a 

rechargeable type.

■

To use the remote controller, point it at the AV receiver’s 
remote control sensor, as shown below.

■

Use the supplied rack-mounting kit to mount the unit in a 
standard 19-inch rack, as shown below.
Remove the feet of the unit before mounting.

• Leave 1U of space above the unit for ventilation.
• Allow at least 10 cm (4 in) at the rear of the unit for ventilation.

Batteries (AA/R6)

Remote control sensor

AV receiver

Approx. 16 ft. (5 m)

Bracket