Tascam SN29401376 User Manual

*1

• The video preview is not displayed when:

– HDMI IN 6/7 is the current HDMI input source, or
– No signal is present on the current input source.

• The video of the currently-selected input is displayed on the 

main screen, not on a preview thumbnail.

*2

This setting cannot be used with the NET input selector.

*3

Only when you have selected “Custom” in the “Picture 
Mode” (

➔ page 56), pressing ENTER allows you to adjust 

the following items via the Quick Setup: “Brightness”, 
“Contrast”, “Hue” and “Saturation”. Press RETURN to 
return to the “Picture Mode” setting.

*4

Depending on the input source and listening mode, not all 
channels shown here output the sound.

*5

• This setting is not available in either of the following cases:

– The  “Audio TV Out” setting is set to “On” (

➔ page 61).

– “HDMI Control(RIHD)” is set to “On” (

➔ page 60) and 

you’re listening through your TV speakers.

You can change various audio settings from the Quick 
Setup (

• These settings are not available in either of the following cases:

– The  “Audio TV Out” setting is set to “On” (

– “HDMI Control(RIHD)” is set to “On” (

➔ page 60) and 

you’re listening through your TV speakers.

■

`

–10dB to 0dB to +10dB in 2 dB steps

You can boost or cut low-frequency sounds output 
from the front speakers.

■

`

–10dB to 0dB to +10dB in 2 dB steps

You can boost or cut high-frequency sounds output 
from the front speakers.

You can adjust the bass and treble for the front speakers, 
except when Direct or Pure Audio (European models) 
listening mode is selected.

■

`

–15dB to 0dB to +12dB in 1 dB steps

■

`

–12dB to 0dB to +12dB in 1 dB steps

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to standby. To save the setting you made 
here, go to “Level Calibration” (

setting the AV receiver to standby.

• You cannot use these function while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is 

connected.

• Speakers that are set to “No” or “None” in 

➔ page 50) cannot be adjusted.

■

■

■

See “Dynamic Volume” in “Source Setup” (

• These technologies can be used when all the following conditions 

are met:
– Room Correction and Speaker Setup is completed. Note that 

“Audyssey” requires the “Audyssey 2EQ Full Calibration” 
method.

– Any listening mode other than Direct or Pure Audio (European 

models) is selected.

– A pair of headphones is not connected.

• The setting is stored individually for each input selector.