Tascam SN29401376 User Manual

■

`

Wide:

Select if the listening angle is greater than 30 degrees.

`

Narrow:

Select if the listening angle is less than 30 degrees.

With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the 
front left and right speakers relative to the listening 
position. Ideally, the front left and right speakers should be 
equidistant from the listening position and at an angle close 
to one of the two available settings.

• For best results, we recommend setting “

” to 20° and 

“Wide” to 40°.

Items can be set individually for each input selector.

■

`

Off 

`

Movie:

Select this setting for movie material.
The Audyssey indicator will light.

`

Music:

Select this setting for music material.
The Audyssey indicator will light.

• When “Audyssey Quick Start” has been used for measurement, 

“Audyssey” cannot be selected.

• Audyssey equalizing does not work with DSD sources.

■

`

Off 

`

On:

Audyssey Dynamic EQ

®

 becomes active.

The Dynamic EQ indicator will light.

With Audyssey Dynamic EQ, you can enjoy great sound 
even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorating 
sound quality as volume is decreased by taking into 
account human perception and room acoustics. It does so 
by selecting the correct frequency response and surround 
volume levels moment-by-moment so that the content 
sounds the way it was created at any volume level — not 
just at reference level.

■

`

:

This should be selected for movie contents.

`

5dB:

Select this setting for content that has a very wide 
dynamic range, such as classical music.

`

10dB:

Select this setting for jazz or other music that has a 
wider dynamic range. This setting should also be 
selected for TV content as that is usually mixed at 
10 dB below film reference.

`

15dB:

Select this setting for pop/rock music or other 
program material that is mixed at very high listening 
levels and has a compressed dynamic range.

Front left speaker

Front right speaker

Listening angle: 30°

Preparation
Press the input selector buttons to select an input source.

The tone for each speaker is set automatically by 
Audyssey 2EQ

®

 Room Correction and Speaker Setup. 

To enable the following settings, you must first perform 
the Room Correction and Speaker Setup (

➔ page 32).

• These technologies cannot be used when:

– a pair of headphones is connected, or
– either Pure Audio (European models) or Direct 

listening mode is selected.

“Setup”