Tascam SN29401376 User Manual

Page of 96
Controlling Other Components
En-70
You’ll need to enter a code for each component that you 
want to control.
Note
• Though the provided remote control codes are correct at the time 
of release, they are subject to change.
You can change the configuration of colored buttons, with 
which REMOTE MODE buttons are preset.
Tip
• To reset the REMOTE MODE buttons to their default settings, 
Note
• If any other button than the colored buttons is pressed, the 
operation will be cancelled.
• This operation cannot be done while the AV receiver is in 
Receiver mode or when ZONE 2 is active.
Entering Remote Control Codes
1
Look up the appropriate remote control code in the 
separate Remote Control Codes list.
The codes are organized by category (e.g., DVD 
player, TV, etc.).
2
While holding down the 
REMOTE MODE button to 
which you want to assign a code, press and hold 
down 
DISPLAY (about 3 seconds).
The remote indicator lights.
Note
• Remote control codes cannot be entered for RECEIVER 
and the multi zone button.
• Only TV remote control codes can be entered for TV.
• Except for RECEIVERTV, and the multi zone button, 
remote control codes from any category can be assigned for 
the REMOTE MODE buttons. However, these buttons also 
work as input selector buttons (
REMOTE MODE button that corresponds with the input to 
which you connect your component. For example, if you 
connect your CD player to the CD input, choose TV/CD 
when entering its remote control code.
3
Within 30 seconds, use the number buttons to enter 
the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered successfully, 
the remote indicator will flash once slowly.
Remapping Colored Buttons
1
While holding down the 
REMOTE MODE button 
that you want to program, press and hold down 
(Red) until the remote indicator lights (about 3 
seconds).
You can only change colored buttons for components 
whose codes belong to categories of the Remote 
Control Codes list (BD/DVD player, TV, cable set-top 
box, etc).
2
Within 30 seconds, press the colored buttons in the 
order that you want to reassign them.
The button presses are assigned to each button from 
left to right. The remote indicator flashes twice, 
indicating that the sequence has been successfully 
assigned. If the sequence is not successfully assigned, 
the remote indicator will flash once slowly.