JVC TH-R1 User Manual

Page 16Friday, 8 April 2005  16:00

Filename [TH-R1R3EK_05Name.fm]

Masterpage:Left+

●

When you connect speakers other than the supplied ones, use 
speakers of the same speaker impedance (SPEAKER 
IMPEDANCE) indicated near the speaker terminals on the rear of 
the powered subwoofer.

●

DO NOT connect more than one speaker to one speaker 
terminal.

●

When moving the speakers, do not pull the speaker cords; 
otherwise, the speakers may fall over, causing damage or injury.

●

Do not reproduce sounds at so high a volume that they are 
distorted; otherwise, the speakers may be damaged by internal 
heat build-up.

●

When holding a speaker, always grasp the lower portion. (TH-R3)

●

Do not lean against the speakers, as the speakers could fall 
down or break, possibly causing an injury. Especially make sure 
that children do not lean against them. (TH-R3).

Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.

Front speakers
SP-THS55F

Powered subwoofer SP-PWR1

Center speaker SP-THS55C

Surround speakers
SP-THS55S

●

Connect the black cords to the black (G) terminals.

●

Connect the white cords to the (F) terminals
referring to the table below:

FRONT SPEAKERS (LEFT)

White

FRONT SPEAKERS (RIGHT)

Red

CENTER SPEAKER

Green

SURROUND SPEAKERS (LEFT)

Blue

SURROUND SPEAKERS (RIGHT)

Grey

Speaker cord

The satellite speakers are equipped with their speaker cords attached directly to their speaker unit instead of 
having speaker terminals on their cabinet.

4 m

10 m

4 m

Center speaker 
SP-THS66C

Surround speakers
SP-THS66S

Front speakers
SP-THS66F

Powered subwoofer 
SP-PWR3

White

Black

Black

Red

4 m

10 m

4 m

TH-R1R3EK_00.book  Page 16  Friday, April 8, 2005  4:00 PM