Epson 3000/3500/3510/3600e Owner's Manual
Charging the 3D Glasses
Charge the glasses when the status light on the glasses flashes red to indicate a low battery.
1.
Connect the smaller end of the charging cable to the port on the bridge of the glasses.
Note: Make sure you connect the cable in the correct orientation or you may damage the glasses or
cable.
cable.
2.
Connect the other end of the cable to the USB Type A port on the projector or any other device such
as a computer that has an active USB Type A port.
as a computer that has an active USB Type A port.
Note: The projector must be turned on to charge the glasses.
The glasses are fully charged when the status light on the glasses stays green.
Parent topic:
54